SMES

Superconducting Magnetic Energy Storage (often shortened to SMES, pronounced ss-mess) systems store energy in a magnetic field. The power is collected by means of a terminal: . In order for these to charge and power the station you must know the approximate power level going into the unit. Then set the SMES to charge and set the input level to as close as you can but not over the power level you know is going into it. If the ship keeps losing power you can set the output of the SMESes higher, but you should only set the output power greater than the input power as a temporary emergency measure for obvious reasons. Always try to have the SMESes charging so you have backup power in case there are problems with the Engine.

Keep in mind every SMES you don't use or that you feel is critical, you can adjust the input up on it to help it charge. Also remember that if it isn't charging because there isn't adequate power to cover all your inputs and it doesn't have much backup power, it will automatically turn off. Proper maintenance of your SMESes can have you operate a ship at enormously low power levels. Also that your maximum usage will not always directly represent your input levels in all the SMESes. It will be close, and as such make sure you know what your power drain is. Remember, if the Engine isn't providing enough power for your SMESes input level, then your SMESes are not going to charge.

Working with SMESes

This information is based off my experiences aboard the NSS Cyberaid.

First of all, you must recognize that power aboard NSS Cyberaid is an important task. There are currently two main elements to power. You have the Singularity and the Solars to generate the power, and you have SMESes to distribute and store it.

This focuses on SMESes. For a guide to the engines themselves, head to the apropriate sections.

NSS Cyberaid has Three "Primary" SMES units, two SMES for the AI and a SMES for every Solar Array. Also there are some SMES set up at the Mining Station, the Research Outpost, the Telecoms Satellite and the Engineering Outpost. The Primary ones are located in the room directly east to the Particle Accelerator. The power is generated from the Radiation Collectors, which are directly fed into the SMES's. The SMES's of the Solar Array are directly fed by the connected Arrays and feed into the same power main grid, as the Primary SMES units. The AI SMES's are a isolated power supplies for the AI - which aren't fed by any source, which also is true for SMES units in the Mining Station and the Research Outpost. The SMES in the Telecoms Satellite and Engineering Outpost should have power soruces, but also don't need any maintenance from Engineers.

The Three Main SMES's and Engineering Power directly convert the Radiation Collector's output into usable power. Since you can get an exact amount of power the Engine is outputting, you can figure out exactly how much input you can do.

Primary Power

First of all, the locations. Your primary SMESes are in the room directly to the right of the Particle Accelerator. The terminal in both the SMES room, and in the Engineering Break Room can show you how much power the Engine outputs, as well as the amount of power the Primary SMESes in put out, while the Power Monitering Computer in both the CE's Office and the SMES room will tell you where all the power is used.

Adjusting the SMESes

You need to ensure you provide enough power in the SMES outputs to fill the power. If absolutely necessary, the Station can run on a single SMES, but the Engine will need to provide the maximum amount of power to maintain this. It is suggested to have the unnecessary SMES's charging as well, so in the case of Engine failure, the Station still has power. The SMESes will use the full output in sequence. Everything in addition to the output that is used (not set, but used) will go to the SMES's charge.